weberbase coat X
weberbase coat X
weberbase coat X plaster is a polymer-modified dry powder cement-based render mortar. Suitable for direct finishes on Gyproc® Glasroc X gypsum board and application with fiberglass mesh 160g on Glasroc X facade wall system.
Packaging
- 25 kg
Application area
Floor, Wall
• Density 1.30 g/cm3.
• Chemical curing time 2-3 mins
• Pot life 120 mins
• Application temp +5°C and +35°C
• Time to cover with paints or wall paper 3-7 days
- Smooth and easy application
- Perfectly work with Glasroc X gypsum board for external application.
- Good bonding, dustless
- Suitable for 2-5 mm. thickness
- Add approximately 6.25 Liters of clean water in a clean bucket.
- Gradually add 25 kg of mortar (the full bag) while mixing with the electrical spindle mixer.
- If mixing more than one bag, the mixing ratio of water per bag is around 24 – 27%.
- Avoid to create air bubble while mixing.
- Mix properly for at least 3 minutes until getting lump-free homogeneous paste.
- Apply weberbase coat X on the joint with the width at maximum 3 mm.
- Embed immediately 160 g Mesh, which cut in size of 10-15 cm, along all the vertical and horizontal joints.
- Apply another thin layer of weberbase coat X on top and make sure that 160 Mesh is completely embedded in.
- Apply the first layer 2 mm of weberbase skim coat X.
- Embed the mesh 160g vertically or horizontaly immediately on the first layer of weberbase coat X when fresh.
- Apply another 2 mm on the second layer (wet on wet) until getting the required thickness (4 mm upper) and make it smooth.
- After at least 1 day, skim coat surface to make it smoother if required.
- After another one day, painting application can be done.
- Ensure the rendering surface is free from dirt, dust, oil, grease, paint, silicone or friable material.
- Joints and screw head areas should be installed and treated properly before render applied.
